The power of the car comes from the engine. Today we will look at the proper steps to remove the engine.
Remove the battery cable to avoid accidental damage to the electrical equipment.
Adjust the air conditioner switch to "warm air" to ensure complete discharge of coolant.
Open the radiator cover and coolant bucket cover, and remove the large circulation interface of the water pump. Drain the coolant into the container, then gently remove the rest of the pump, and at the same time connect the coolant to the container for backup.
Remove the plug of radiator double temperature switch and electric fan.
Release engine hood lock cable clamp and pull cable from above radiator.
Remove front engine mask and baffle. First loosen the six nuts holding the front mask cover and the two fixing bolts on the left and right of the radiator, and remove the front bumper, as shown in Figure 3. Loosen the four hex retaining nuts on the front of the front mask and remove the front mask.
Loosen the two screws holding the condenser in place on the stringer.
Related content Illegal climbing taken from experience
Remove the intake from the gasoline pump; Unplug the radiator electric fan thermal switch wire plug installed on the carburetor, the oil pressure switch wire plug, the high voltage cable on the distributor cover and the vacuum connector connected to the carburetor, distributor and intake manifold.
Remove the deflector cover above the air filter and carburetor, and seal the top of the carburetor with a film to prevent foreign matter from falling on people
Remove the throttle cable and spring from the carburetor.
Remove the coolant soft on the carburetor and the coolant soft on the machine connected to the warm air.
Unplug the lead plug from the coolant temperature sensor and the lead plug from the starter.
Remove the starter fixing bolt and the starter fixing frame and the bolt connecting the front suspension with the longitudinal beam, and remove the starter; Remove the clutch cable and engine ground cable.
Loosen engine rear support cover and remove exhaust.
Remove engine and transmission retaining bolts and engine rear suspension bolts, and remove flywheel cover.