Hand-pushed floor washing machine is a very practical tool for cleaning the ground, such as stone floor, cement floor, epoxy floor and other hard ground can be used. The following will introduce the complete use steps of the hand-pushed floor washer.
Push-type floor washer
Install the front brush tray and the rear suction scraper.
Put down the brush tray and suction bar, turn on the power and switch on the brush tray and suction bar.
Hold the washing machine well, maintain a constant speed, and lift the absorbent scraper and brush tray when encountering bumps.
After the end of use, empty the sewage tank and rinse it clean.
The rear suction strip will wear more seriously after a long time of use, is higher from the ground, and can not absorb water when used, then you only need to remove the rubber and adjust the height.
Both sides of the rubber on the absorbent strip can be used repeatedly.
If there are water marks on the ground when cleaning the ground, it can be solved by lifting the absorbent scraper and wiping it with a rag.