Encyclopedia

1570Currently online
19Today's Reading
49Share Today
Multilingual display

How to debug the newly bought injection molding machine?

2018-05-08 12:48:12

First, the lifting and disassembly of the injection molding machine use a powerful enough hoist and handling machine to lift the machine. If any hanging wire rope is in contact with the machine, a cloth layer or wood block should be placed between the wire rope and the machine to avoid damaging the parts of the machine, such as the pull rod of the injection molding machine.

Methods/Steps
1

Anti-rust, the installation of the Kumar machine needs to spray anti-rust oil, all mechanical parts exposed to the air, such as the piston column, tie rod and formwork part of the machined surface, are coated with anti-rust agent before discharge. The mixture of lubricating oil and clean hydraulic oil on the bearing surface can produce a rust-proof film.

2

Installation environment 0~40℃(ambient temperature during operation); Humidity: Below 75% (relative humidity), no condensation. Altitude: Below 1000 meters above sea level. When the humidity is too high, the insulation will be poor, the parts will age in advance, do not install the injection molding machine in a humid environment

Recommendation